Lumina V6-3.8L VIN K (1998)
Power Steering Hose/Pipe Routing (Part 2 Of 2)
2. Power steering pressure line at pump.
3. Power steering pressure line at steering gear.
-
The pressure line is the lower line at the steering gear.
-
Use a 18 mm crow's foot line wrench with a 2 foot, 3/8 inch drive extension.
-
Access line from engine compartment, between the rocker arm cover and front of dash mat.
4. Raise and suitably support vehicle.
5. Power steering gear line clamps at steering gear.
6. Power steering pressure line from vehicle.
Install or Connect
1. Power steering pressure line into vehicle.
2. Power steering gear line clamp at steering gear.
3. Lower vehicle.
4. Power steering pressure line at steering gear.
-
Use a 18 mm crow's foot line wrench with a 2 foot, 3/8 inch drive extension.
Important: Ensure rubber sleeve contacts transaxle brace as an anti-rotational feature.
5. Power steering pressure line at pump.
6. Accessory drive belt.
7. Fill system.
8. Bleed the system.
Inspect
-
For leaks. Refer to Testing and Inspection.
PWR Str Fluid Cooling Pipe and Reservoir Inlet Hose (Ret Line)
