Lumina V6-3.8L VIN K (1998)
8.
Install the new pressure power steering pipe/hose assembly (1), P/N 26075972 and hand start the fitting at the power steering pump. See Figure.
9.
Position the pressure pipe/hose assembly so that the rubber sleeve lightly contacts the transmission support bracket and tighten the fitting at the
pump to 27 N.m (20 lb ft). See Figure.
10.
Route the new assembly, forming a loop in the hose (See Figure), and hand start the fitting at the power steering gear.
11.
Secure the metal pipe portion of the pipe/hose assembly (1) to the steering gear with the tie strap (2), P/N 11509087. See Figure. Secure the
Oxygen Sensor wiring harness clip.
12.
Tighten the pipe/hose fitting at the power steering gear to 27 N.m (20 lb ft).
13.
Inspect and verify that a minimum clearance of 25 mm (1 in) exists between the hose/exhaust manifold heat shield and also between the hose/front
of dash (3). See Figure.
14.
Raise the frame/cradle assembly up to the underbody of the vehicle.
15.
Install and tighten the cradle bolts to 180 N.m (133 lb ft) and lower the vehicle.
16.
Bleed the power steering system, following the procedure in the Power Steering System sub-section of the Service Manual.
Parts Information
Part Number
Description
Power Steering Pressure Hose
26075972
Assembly
11509087
Tie Strap
Parts are currently available from GMSPQ.
Warranty Information
For vehicles repaired under warranty. use:
Labor
Labor
Operation
Description
Time
E8622
Hose, Power Steering
0.7 hr
Pressure - Replace
