Lumina V6-3.8L VIN K (1998)
22.
While holding the center nut with a wrench, tighten the forcing screw to remove the bearing from the housing. Refer to Figure 7.
Important
Inspect the gear housing to ensure that all pieces of the old bearing have been removed.
23.
Apply a small quantity of lubrication (e.g., multi-purpose grease or power steering fluid) inside of the housing bore where the new bearing will be
installed.
24.
Center the new bearing over the pinion thread. The bearing can be installed with either side facing outwards.
25.
Place the bearing installer (1) J 44714-2 (included in J 44714-B) over the pinion thread. Refer to Figure 8. If necessary, use the extension included
with the installer. Lightly tap the bearing installer with a hammer until the bearing is seated in the housing.