Lumina V6-3.8L VIN K (1998)
10.
Raise the rear of the engine cradle and install the six bolts. Refer to Figure 12.
Tighten
^
Tighten the rear suspension crossmember bolts (1) to 110 Nm (81 lb ft).
^
Tighten the suspension crossmember to body bolts (2) to 82 Nm (60 lb ft).
11.
Install the one bolt and two nuts that attach the rear transmission mount to the engine cradle.
Tighten
Tighten to 66 Nm (49 lb ft).
12.
Install both outer tie rod ends to the knuckles.
Tighten
Tighten to 45 Nm (33 lb ft).
13.
Install both front tire and wheel assemblies.
Tighten
Tighten to 140 Nm (103 lb ft).
14.
Lower the vehicle.
15.
Add power steering fluid and bleed the system.
16.
Check the alignment and set toe-in as necessary.
17.
Close the hood.
97-98 Regal, 98 Intrigue
Lower Pinion Bearing Inspection -- 1997-1998 Buick Regal, 1998 Oldsmobile Intrigue
The following service procedure is for inspection of the lower pinion bearing and can be performed without completely removing the steering gear
from the vehicle.
Tools Required
^
J 44714-B Pinion Bearing Remover
^
J 24319-B Steering Linkage and Tie Rod Puller
1.
Open the hood.
