Lumina V6-3.8L VIN K (1998)
12. Ensure the conduit is fully engaged.
IMPORTANT: The horseshoe clip with the tab is flush when fully engaged.
13. The horseshoe clip with the tab is not flush when not fully engaged.
14. Install the shift cable retainer and the wiring harness clip or the wiring harness strap.
A/T Range Selector Cable Replacement (at PNP Switch)
REMOVAL PROCEDURE
CAUTION: The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two
metal couplings from one another Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings
occurs. When servicing the transaxle remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range
selector cable bracket. If either section of the cable needs to be replaced, replace both of the cable sections. Loss of connection integrity of the
two metal couplings can cause loss of transaxle shift control which could result in personal injury.
1. Remove the throttle body air inlet duct. Refer to Powertrain Management.
2. Remove the automatic transaxle range selector cable from the wiring harness clip or strap.
3. Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
