Lumina V6-3.8L VIN K (1998)
6. Engage the automatic transaxle range selector cable retainer to the console shift control.
7. Install the automatic transaxle range selector cable to retaining clip(s) or retainer(s) in the passenger compartment.
8. Install the carpet into position. Refer to Seats and Carpet.
9. Install the console. Refer to Instrument Panel, Gauges and Warning Indicator.
10. Install the automatic transaxle range selector cable to wiring harness clip(s) or retainer(s) in the engine compartment.
11. Adjust the automatic transaxle range selector cable. Refer to AT Range Selector Cable Replacement (New Cable Installation Only) and/or AT
Range Selector Cable Adjustment.
A/T Range Selector Cable Replacement (at Column Shift Control)
REMOVAL PROCEDURE
CAUTION: The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two
metal couplings from one another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings
occurs. When servicing the transaxle remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range
selector cable bracket. If either section of the cable needs to be replaced, replace both of the cable sections. Loss of connection integrity of the
two metal couplings can cause loss of transaxle shift control which could result in personal injury.
1. Remove the automatic transaxle range selector cable retainer from the stud in the engine compartment.
2. Remove the steering column trim panel. Refer to Instrument Panel, Gauges and Warning Indicator.
3. Remove the automatic transaxle range selector cable from the shift control lever.
