Lumina V6-3.8L VIN K (1998)
1. Install the O-ring (11) to the vehicle speed sensor (10).
2. Install the vehicle speed sensor (10) to the extension case.
3. Install the vehicle speed sensor bolt (9).
^
Tighten the vehicle speed sensor bolt to 11 Nm (97 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the vehicle speed sensor wiring harness connector.
5. Install the right engine splash shield.
6. Install the right front tire and wheel. Refer to Wheel Installation in Wheels and Tires.
7. Lower the vehicle.
