Lumina V6-3100 3.1L VIN M SFI (1995)
13.
Accessory drive belt from generator. Refer to Engine Mechanical or Section 6A9A of the Service Manual.
14.
Generator rear brace,
15.
Power steering gear pipe clip from generator stud (if applicable). Refer to Section 3B of the Service Manual.
16.
Generator to engine fasteners.
17.
Generator.
Install or Connect
1.
Generator.
2.
Generator to engine fasteners.
3.
Generator rear brace.
4.
Power steering gear pipe clip to generator stud (if applicable). Refer to Section 3B of the Service Manual.
5.
Accessory drive belt to generator. Refer to Engine Mechanical or Section 6A9A of the Service Manual.
6.
Generator "BAT" terminal lead and nut to generator.
7.
Electrical connector to generator.
8.
Generator cooling duct.
9.
Using the jacking fixture, raise the frame rear until the frame insulators contact the vehicle body.
10.
New frame rear bolts. Refer to Section 10-3 of the Service Manual.
11.
Intermediate shaft to steering gear and lower pinch bolt. Refer to Section 3B of the Service Manual.
12.
Right engine splash shield. Refer to Section 4D of the Service Manual.
13.
Both front wheels. Refer to Section 3E of the Service Manual.
14.
Lower the vehicle.
15.
Ignition control module with mounting bracket on 1996 vehicles. Refer to Engine Controls or Section 6E3 of the Service Manual.
16.
Battery negative cable to the battery negative terminal. Refer to Section 6D1 of the Service Manual.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
Description
Labor Time
J4100
Generator Assembly -
1.4 hrs
Replace
Add
Diagnosis
0.3 hr
Add
Locking Wheel
0.1 hr
Covers/Nuts (one or all)
