Lumina V6-3100 3.1L VIN M SFI (1995)
Fig. 12 Exploded View Of Power Rack & Pinion Assembly
INSTALLATION
1. If valve body rings are to be replaced, apply grease to ring grooves and rings and Install new rings, ensure split tabs are engaged and staggered,
Fig. 12.
2. Place pinion and valve assembly into clear pinion and valve assembly ring protector tool No. 37090, or equivalent. Allow to set for at least three
minutes.
3. Center rack in housing, refer to measurement "A" taken during disassembly.
4. Wipe housing bore clean and apply grease to valve housing bore. Inspect stub shaft bearing annulus for damage and ensure bearing is flush with