chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Suspension Spring ( Coil / Leaf )|Service and Repair > < Suspension - Loose Lumber Noise From Rear
Page 1
background image

Suspension Spring ( Coil / Leaf ): All Technical Service Bulletins
Suspension - Loose Lumber Noise From Rear

File in Section: 3 - Steering/Suspension

Bulletin No. 53-34-05

Date: September, 1995

Subject: 
Loose Lumber Noise from Rear of Vehicle (Replace Rear Coil Springs)

Models: 
1995 Chevrolet Lumina, Monte Carlo

Plant VIN - Breakpoint
Oshawa # 1 - SOP through S9167826
Oshawa # 2 - SOP through S1185040

Condition

Some vehicles assembled between VIN breakpoints indicated above may exhibit a loose lumber type noise most apparent during low speed operation
over an irregular road surface.

Cause

Noise generated by coils of rear springs contacting one another and being transmitted into vehicle passenger compartment.

Correction

Replace existing rear coil springs with new springs following applicable service procedure in the Service Manual, Section 3D, Rear Suspension. Proper
new spring selection can be made by identifying existing springs by the three letter code on the tag attached to springs and referencing chart.

Parts Information

Parts are currently available from GMSPO. 

Warranty Information

For vehicles repaired under warranty, use:

Labor Operation

Labor Time

E5027

Use published labor operation time.

Suspension Spring ( Coil / Leaf )|Service and Repair > < Suspension - Loose Lumber Noise From Rear