Lumina APV V6-191 3.1L (1990)
Weatherstrip: Customer Interest
Doors, Front - Wavy or Puckered Outer Belt Seal Strips
Number:
90-69-10
Section:
10
Date:
October 1989
Corporate Bulletin No.: 931050
Subject:
WAVY OR PUCKERED OUTER BELT SEAL STRIPS ON FRONT DOORS
Model and Year:
1990 U VAN
TO:
ALL CHEVROLET DEALERS
Some early model 1990 U-vans may exhibit wavy or puckered outer belt sealing strips on the front doors. This condition may be noticed in the curved
section of the seal strip.
This condition may be addressed by using the following procedure and it will not be necessary to replace the outer belt seal strips.
Procedure:
1.
Raise the door glass to full up position.
2.
Using a heat gun, carefully heat the outside surface of the seal strip.
NOTICE:
BE CAREFUL NOT TO HOLD THE HEAT GUN TOO CLOSE TO THE PANEL, AS PAINT DAMAGE COULD OCCUR.
3.
Using a cloth to protect finger tips, carefully press the wavy or puckered area to better conform to the glass surface.
Labor Operation:
T1537 (One or Both Sides)
Labor Time:
.2 Hours (Both Sides)
