Lumina APV V6-191 3.1L (1990)
4.
Install J 39177 on the combination valve (figure 2).
5.
Check the master cylinder reservoir fluid level and fill if needed.
6.
Bleed the brakes as described in SECTION 5.
7.
Close the internal bleed valves.
TIGHTEN
*
Internal bleed valves (A) to 7 N-m (60 lbs.In.).
8.
Remove the three J 39177 Combination Valve Pressure Bleeding Tools.
9.
Check the master cylinder reservoir fluid level and fill if needed.
10.
With the Ignition switch "ON" and the engine off, do six function tests with the Tech-1 scan tool.
11.
Repeat the wheel cylinder and caliper bleed procedure as many times as needed to remove the remaining air in the hydraulic system.
12.
Apply firm pressure to the brake pedal and evaluate brake pedal feel.
13.
Repeat the bleed procedure if needed.
Make sure you have a good, hard brake pedal before starting the engine and moving the vehicle.
