Lumina APV V6-191 3.1L (1990)
4.
Remove air cleaner assembly.
5.
Remove accelerator cable retaining clip and accelerator cable from TBI throttle lever.
6.
Squeeze and push accelerator cable retaining tangs (2) at the throttle body bracket and remove accelerator cable.
INSTALLATION
NOTE:
a.
Use care when pressing the retainer into hole in rod to ensure that the cable is not kinked or damaged in any way.
b.
To prevent possible interference, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2") of moving parts unless
routing is positively controlled.
c.
Wire, hoses, cables, or other obstructions must not be placed within 13 mm (1/2") of cable or rod at any point in their travel.
1.
Connect the accelerator cable to the throttle body bracket.
2.
Install accelerator cable and retaining clip to the throttle lever.
3.
Install the air cleaner assembly.
4.
Feed the accelerator cable through the dash panel bulkhead and snap cable retainers into accelerator pedal assembly bracket.
5.
Connect accelerator cable to accelerator control lever.
6.
Install vehicle instrument panel lower trim and courtesy light.
7.
Check for complete throttle opening and closing by operating accelerator pedal. Also check for poor carpet fit under the accelerator pedal. Throttle
should operate freely without binding between fully closed and wide open throttle.
8.
Apply heavy bodied sealer around the accelerator cable at the engine compartment side of dash panel bulkhead.
Accelerator Pedal Assembly
ACCELERATOR PEDAL ASSEMBLY
REMOVAL:
1.
Remove lower instrument panel trim attaching screws (5) and clip. Partially drop lower instrument panel trim and disconnect the courtesy light.
