Malibu L4-144 2.4L DOHC VIN T SFI (1998)
11. In order to reload the timing chain tensioner assembly to its zero position, form a keeper from a piece of heavy gauge wire.
12. Apply a slight force on the tensioner blade in order to compress the plunger.
13. Insert a small screwdriver into the reset access hole, and pry the ratchet pawl away from the ratchet teeth while forcing the plunger completely in
the hole.
14. Install the keeper between the access hole and the blade.
15. Install the tensioner assembly to the chain housing. Recheck the plunger assembly installation, it is correctly installed when the long end is toward
the crankshaft.
16. Install the timing chain tensioner bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
17. Lower the vehicle enough to reach and remove the alignment dowel pins.
18. Rotate the crankshaft clockwise (normal rotation) two full rotations.
19. Align the crankshaft keyway with the mark on the cylinder block and reinstall alignment dowel pins.
20. Alignment dowel pins will slide in easily if the engine is timed correctly.
21. Install the timing chain guides.
22. Install the engine front cover. Refer to Engine Front Cover Replacement.
23. Connect the negative battery cable.
