Malibu L4-2.2L VIN F (2005)
10. Remove the support assembly to body bolts.
11. With the aid of an assistant, remove the support assembly from the vehicle.
12. Remove the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft.
2. With the aid of an assistant, position the support assembly to the vehicle.
3. Using a suitable jack stand, support the support assembly.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the support assembly to body bolts.
Tighten the bolts to 90 Nm (66 ft. lbs.) plus 60 degrees plus an additional 15 degrees.
5. Remove the jack stand.
6. Install the muffler assembly.
7. Connect the vehicle wiring harness to the clips on the support assembly.
