Malibu L4-2.4L (2010)
13. Remove the wire or string from the hood release cable.
Installation Procedure
1. Tie the wire or string to the hood release cable.
2. Install the hood primary latch release cable through the hole in the instrument panel.
3. Install the hood release cable through the instrument panel using a small flat-bladed tool until the grommet is fully seated.
4. Remove the wire or string from the hood release cable.
5. Install the hood latch release cable ball to the latch.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the hood latch fasteners and tighten to 10 Nm (89 lb in).
7. Install the upper fascia support.
8. Install the knee bolster to the instrument panel.
9. Install the hood latch release cable handle to the instrument panel.
