Malibu L4-2.4L (2010)
Sunroof / Moonroof Track: Procedures
Sunroof Track Timing/Synchronization
Removal Procedure
1. Place the module in the full open position.
2. It is only necessary to lower the headliner. Only perform the steps in headliner replacement procedure that will lower the headliner enough to gain
access to the part. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair)..
3. Disconnect the electrical connector from the motor/actuator.
4. Remove the motor. Refer to Sunroof Motor/Actuator Replacement (See: Sunroof / Moonroof Motor/Service and Repair).
5. Push the window guides rearward on the track until the guides are positioned against the rear hard stop.
Installation Procedure
1. Install the motor. Refer to Sunroof Motor/Actuator Replacement (See: Sunroof / Moonroof Motor/Service and Repair).
2. Connect the electrical connector to the motor/actuator.
3. Install the headliner. Refer to Headlining Trim Panel Replacement (See: Interior Moulding / Trim/Headliner/Service and Repair).
4. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process (See: Sunroof / Moonroof
Motor/Testing and Inspection).
5. Verify the operation of the sunroof.
