Malibu L4-2.4L (2010)
4. Hold the rotor firmly in place against the hub/axle flange and install one of the CH-45101-100 - conical brake rotor washers (1), and one lug nut
(2) onto the upper-most wheel stud.
5. Continue to hold the rotor secure and tighten the lug nut firmly by hand.
6. Install the remaining CH-45101-100 - conical brake rotor washers and lug nuts onto the wheel studs and tighten the nuts firmly by hand in a
star-pattern.
7. Using the CH-39544-KIT - complete torque socket set - 10 pcs, or equivalent, tighten the lug nuts in a star-pattern to specification, in order to
properly secure the rotor. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. If the brake rotor has been REFINISHED or REPLACED with a new rotor, proceed to step 14.
9. If the brake rotor meets the following criteria, proceed to step 10.
*
The rotor is within specifications and is being REUSED.
*
The rotor has NOT been refinished.
*
The rotor does NOT exhibit thickness variation exceeding the maximum allowable level.