Malibu L4-2.4L (2010)
6. Remove the rear brake hose banjo bolt from the brake caliper.
7. Remove the brake hose from the brake caliper.
8. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
9. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination.
Installation Procedure
Note: Install the NEW copper brake hose gaskets.
1. Remove the caps or plugs from the opening in the brake caliper and the brake hose.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install 2 new copper gaskets, the brake hose and the brake hose-to-caliper bolt to the brake caliper and tighten the bolt to 50 Nm (37 lb ft).
