Malibu L4-2.4L (2010)
8. Connect the electrical connector to the park brake warning lamp switch.
9. Position the carpet back into place.
10. Install the 3 park brake pedal assembly nuts (1, 2, 3) and tighten to 25 Nm (18 lb ft). Tighten in sequence as shown.
11. Pull down to remove the cable tension set pin (1).
12. Apply the park brake pedal 4 full cycles to complete the tension set.
13. Install the left front carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement (See: Body and Frame/Interior
Moulding / Trim/Carpet/Service and Repair/Removal and Replacement/Front Side Door Opening Floor Carpet Retainer Replacement).
14. Install left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Insulator Replacement - Left Side).