Malibu L4-2.4L (2010)
1. Maneuver the vacuum brake booster into position in the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the (2) brake pedal assembly nuts and tighten to 15 Nm (11 lb ft).
3. Install the wave washers (2) and connect the brake pedal pushrod (3) to the pedal pivot pin (4).
Do not apply excessive side pressure on the pushrod.
4. Install the brake pedal pushrod retainer clip (1).
5. Connect the brake pedal position sensor electrical connector.
6. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Insulator Replacement - Left Side).
