Malibu L4-2.4L (2010)
Note:
*
The intake camshaft actuator should not rotate during the removal or installation.
*
Ensure the tips of the tool are fully engaged into the timing chain. The retention tool rod can be used on the back side of the chain to ensure the
teeth from the retention tool are engaged.
11. Install the EN-48749 - retention tool (1) to the intake side of the timing chain.
12. Install the EN-48749 - retention tool (1) to the exhaust side of the timing chain.
13. Remove and discard the intake camshaft actuator bolt (1).
14. Rotate the exhaust camshaft clockwise slightly to take the tension off of the timing chain on the intake actuator.
15. Remove the intake camshaft actuator (3) from the camshaft while also removing the actuator from the timing chain.
Installation Procedure
