Malibu L4-2.4L (2010)
4. Remove the connecting rod nuts and the connecting rod cap.
Discard the bolts and nuts.
5. Remove the connecting rod and the piston out of the top of the engine block using the EN-43966-1 - guides.
6. Clean the cylinder bores with hot water and detergent or with a light honing.
7. Swab the bores with the engine oil and a clean, dry cloth.
Installation Procedure
1. Coat the following parts with engine oil:
*
The piston
*
The piston rings
*
The cylinder bore
*
The bearing surfaces
