Malibu L4-2.4L (2010)
1. Lubricate the solenoid valve O-ring seals with clean engine oil.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the intake (2) CMP actuator solenoid valve and bolt, if required.
Tighten the bolt to 10 Nm (89 lb in).
3. Install the exhaust (1) CMP actuator solenoid valve and bolt, if required.
Tighten the bolt to 10 Nm (89 lb in).
4. Connect the engine wiring harness electrical connector (2) to the intake CMP actuator solenoid valve (3), if required.
5. Connect the engine wiring harness electrical connector (1) to the exhaust CMP actuator solenoid valve (4), if required.
6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (See: Tune-up and Engine Performance Checks/Air Cleaner
Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Cleaner Outlet Duct Replacement).
