Malibu L4-2.4L (2010)
Note: Start all of the nuts and bolts by hand before finalizing any of the torques.
1. Install the NEW steering gear oil seals (1) to the steering gear using the J-44586 - remover/installer (2).
2. Ensure the steering gear oil seals (1) are fully seated in the steering gear.
Caution: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
3. Position the power steering gear outlet hose to the vehicle.
4. Install the steering gear. Refer to Steering Gear Replacement (See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Steering
Gear Replacement).
