Malibu L4-2.4L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Secure the 12 control valve body bolts (2) M6 x 97 and tighten in sequence to 10 Nm (89 lb in).
5. Secure the 3 control valve body bolts (1) M5 x 40.5 and tighten in sequence to 8 Nm (71 lb in).
6. Connect the input speed sensor electrical connector (1).
7. Connect the output speed sensor electrical connector (2).
8. Connect the shift position switch electrical connector (3).
9. Install the transmission control valve body cover.
10. If a NEW TCM has been installed into the vehicle, the NEW module needs to be reprogrammed. Refer to Service Programming System (SPS) (
See: Testing and Inspection/Programming and Relearning/Service Programming System (SPS)).
Note: The Service Fast Learn Adapts procedure must be performed when one of the following repairs have been made to the vehicle. Failure to
perform the procedure after one of the following repairs may result in poor transmission performance, as well as transmission DTCs being set:
*
Transmission internal service/overhaul
*
Valve body repair or replacement
*
Control solenoid valve assembly replacement
*
TCM software/calibration update
*
Any service in response to a shift quality concern
11. Perform the Service Fast Learn Adapts. Refer to Service Fast Learn Adapts (See: Testing and Inspection/Programming and
Relearning/6T30/6T40/6T45 - Automatic Transmission).
