Malibu L4-2.4L (2010)
Shift Cable: Adjustments
6T30/6T40/6T45 - Automatic Transmission
Range Selector Lever Cable Adjustment
Warning
The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two metal couplings from one
another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings occurs. When servicing the transaxle
remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range selector cable bracket. If either section of the cable
needs to be replaced, replace both of the cable sections. Loss of connection integrity of the two metal couplings can cause loss of transaxle shift control
which could result in personal injury.
Note: Adjust the automatic transmission range selector cable while the transmission and the gear selector are in the Park position only. Failure to
do so may cause mis-adjustment.
1. Set the park brake and chock the wheels.
2. Verify the transmission range select lever is in the park position.
3. Verify the transmission manual shift lever is in the park position.
4. Release the range select cable adjuster clip (1).
