Malibu L4-2.4L (2010)
Constant Velocity Joint Boot: Service and Repair
Wheel Drive Shaft Inner Joint and Boot Replacement
Wheel Drive Shaft Inner Joint and Boot Replacement
Special Tools
*
J 8059 Snap Ring Pliers (Parallel Jaw)
*
J 35910 Drive Axle Seal Clamp Pliers
Removal Procedure
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
1. If equipped with a small swage ring, use a hand grinder to cut through the swage ring, taking care not to damage the halfshaft bar, in order to
remove the swage ring. Otherwise, remove the small seal retaining clamp with a side cutter. Discard the retaining clamp.
2. Remove the large seal retaining clamp (2) from the tripot joint with side cutters. Discard the large seal retaining clamp.
3. Separate the inboard seal from the trilobal tripot bushing (3) at the large diameter.
4. Slide the seal away from the joint along the halfshaft bar.