Malibu L4-2.4L (2010)
7. Disconnect the washer level indicator electrical connector (1).
8. Disconnect the washer pump electrical connector (2).
9. Remove the washer solvent container nuts (3).
10. Remove the washer solvent container (4) from the left frame rail.
11. Remove and transfer the following components from the washer solvent container:
*
The windshield washer pump assembly and seal-Refer to Windshield Washer Pump Replacement (See: Windshield Washer Pump/Service
and Repair).
*
The washer level indicator and seal-Refer to Windshield Washer Solvent Level Indicator Replacement (See: Sensors and Switches - Wiper
and Washer Systems/Washer Fluid Level Switch/Service and Repair).
Installation Procedure
1. Install the following components to the washer solvent container:
*
The windshield washer pump assembly and seal-Refer to Windshield Washer Pump Replacement (See: Windshield Washer Pump/Service
and Repair).
*
The washer level indicator and seal-Refer to Windshield Washer Solvent Level Indicator Replacement (See: Sensors and Switches - Wiper
and Washer Systems/Washer Fluid Level Switch/Service and Repair).
2. Position the washer solvent container (4) to the left frame rail mounting studs.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the washer solvent container nuts (3) and tighten to 10 Nm (89 lb in).
4. Connect the washer pump electrical connector (2).
5. Connect the washer level indicator electrical connector (1).
6. Connect the washer pump hose to the pump spout.
7. Engage the washer pump hose to the washer container.
8. Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement (See: Body and
Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Front Wheelhouse Panel Splash Shield Replacement).
9. Lower the vehicle.
10. Install the washer container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement (See: Windshield Washer
Solvent Container Filler Tube Replacement).
11. Fill the windshield washer container with clean windshield washer solvent.
12. Inspect the washers for proper operation.
13. Close the hood.
