Malibu L4-2.4L Hybrid (2008)
Important: Ensure that the heater coolant pump bracket tabs (2) are positioned on either side of the heat shield bracket.
3. Position the heater coolant pump (1) and bracket to the heat shield bracket.
4. Install the remaining exhaust manifold heat shield bolt (3).
Tighten the bolt to 23 N.m (17 lb ft).
5. Connect the engine wiring harness electrical connector (1) to the heater coolant pump (2).
6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (See: Engine/Intake Manifold/Service and Repair) .
