chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Relays and Modules - Ignition System > < Diagram Information and Instructions|Page 10462
Page 2
background image

Important:  Rotate the pigtail 90 degrees from vertical before securing the fastener.

1. Install the knock sensor.

Notice:  Refer to Fastener Notice.

2. Install the knock sensor bolt.

Tighten the bolt to 25 N.m (18 lb ft).

3. Install the knock sensor electrical connector pigtail (6) clip to the oil level indicator tube bracket.
4. Connect the engine wiring harness electrical connector (1) to the knock sensor pigtail electrical connector (6).
5. Lower the vehicle.
6. Connect the negative battery cable.

Relays and Modules - Ignition System > < Diagram Information and Instructions|Page 10462