Malibu L4-2.4L Hybrid (2008)
Tech 2 Pass-Thru Method for the Engine Control Module (ECM)
Notice:
Before reprogramming, please check the battery condition to prevent a reprogramming error of any on the modules due to battery discharge. Battery
voltage must be between 12 and 16 volts during reprogramming. If the vehicle battery is not fully charged, use jumper cables from an additional
battery. Be sure to turn off or disable any system that may put a load on the battery, such as automatic headlamps, daytime running lights, interior
lights, heating, ventilation, and air conditioning (HVAC) system, radio, engine cooling fan, etc. A programming failure or control module damage
may occur if battery voltage guidelines are not observed.
The ignition switch must be in the proper position. The Tech 2(R) prompts you to turn ON the ignition, with the engine OFF. DO NOT change the
position of the ignition switch during the programming procedure, unless instructed to do so.
Make certain all tool connections are secure, including the following components and circuits:
^
The RS-232 communication cable port
^
The connection at the data link connector (DLC)
^
The voltage supply circuits
DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming failure or control
module damage may occur.
DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections are
secure and the Tech 2(R) operating software is up to date.
1.
Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Use an additional jump
battery, if necessary. Only use approved Midtronics charger or Jumper Packs, etc. to maintain proper battery voltage during programming.
2.
Reprogram the engine control module (ECM). Refer to SI and Service Programming System (SPS) documentation for ECM programming
instructions, if required.
Claim Information - GM and Saturn Canada Only
For vehicles repaired under this service update, use the table shown.
Claim Information - Saturn US
To receive credit, submit a claim with the information shown.
Disclaimer
