Malibu L4-2.4L Hybrid (2008)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module Replacement (With RPO LAT) (2.4L)
Removal Procedure
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Turn the ignition switch to the OFF position.
2. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
3. Disconnect the electrical connector from the EBCM.
4. Remove the 4 EBCM bolts.
5. Separate the EBCM from the BPMV by carefully pulling the components apart.
Ensure the motor pin connector is removed with the EBCM. A new motor pin is provided with the replacement EBCM.
Installation Procedure
