Malibu L4-2.4L Hybrid (2008)
Notice: Refer to Fastener Notice .
3. Hand start and install the servo cover bolts.
Tighten the servo cover bolts to 12 N.m (9 lb ft).
4. Install the oil pan. Refer to Oil Pan Replacement (See: Fluid Pan/Service and Repair) .
5. Lower the vehicle.
6. Remove the AIR. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General Diagnostics/4T45-E -
Automatic Transaxle/Transmission Fluid Check) .
7. Add DEXRON(R) VI transaxle fluid or equivalent to the specified refill capacity.
*
The bottom pan removal capacity is approximately 6.5 L (6.9 qt).
*
The complete overhaul capacity is approximately 9 L (9.5 qt).
*
The dry capacity is approximately 12.2 L (12.9 qt).
8. Start the engine, warm up the transaxle, and check for leaks.
9. Inspect for proper fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General Diagnostics/4T45-E
- Automatic Transaxle/Transmission Fluid Check) .
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
10. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Description and Operation/4T45-E - Automatic Transaxle/Transmission
Adaptive Functions) .
