Malibu L4-2.4L Hybrid (2008)
9. Remove the right hand axle seal from the transmission. Use the J 23129 and the J 6125-1B .
Installation Procedure
Important: J 41228 must be used in order to install the sleeve to the correct depth.
1. Use J 41228 to install a NEW sleeve on the output axle shaft.
2. Install the collet into the output shaft snap ring groove with the collet attached to the threaded collet shaft.
3. Place the NEW sleeve over the collet.
4. Install the bearing and nut onto the threaded collet shaft.
5. Hold the collet shaft while tightening the nut in order to press the sleeve onto the output shaft.
6. Remove the J 41228 .
