Malibu V6-191 3.1L VIN M SFI (1997)
Keyless Entry Receiver: Service and Repair
Remote Keyless Entry Module Programming
Module Mounting And Wiring (Typical)
A Remote Control Door Lock Receiver can have up to four different transmitters programmed to it. A transmitter can be programed to more than one
vehicle providing the remote keyless entry systems are similar. When reprogramming one transmitter, any and all other transmitters (maximum of four
(4) total per receiver) must be reprogrammed at the same time in order for the other transmitters to work.
Important
^
Leave a window down in the vehicle while reprogramming the Remote Control Door Lock Receiver system. This will avoid unintentional lock out
if the reprogramming procedure is not properly performed.
1. Turn Ignition off.
2. Ground the receiver program terminal by jumping the two terminals located in the program ground connector.
^
No horn within 1 second, Lock, Unlock and Rear Compartment Lid Release will cycle to indicate module is ready for reprogramming.
3. Press and hold the rear compartment lid Lock and Unlock buttons until* Lock, Unlock, Rear Compartment Lid Release, and Horn cycles to
indicate the transmitter has successfully been reprogrammed. (Approximately 12 seconds).
4. Repeat Step 3 for the remaining transmitters.
5. Remove the jumper at the program connector.
6. Verify proper operation of the transmitters.
