chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Lock Cylinder Switch > < Remote Keyless Entry Module Replacement|Page 10131
Page 1
background image

Keyless Entry Transmitter Battery: Service and Repair

Transmitter Battery Replacement

REMOVE OR DISCONNECT

1. Open the transmitter case.

^

Insert a dime between the two halves of the transmitter case at the slot provided near the key ring hole and twist the dime to open the case.

2. Battery

INSTALL OR CONNECT

1. Battery.

^

Use one Panasonic three-volt CR2032 or equivalent battery. Install the battery with the positive (+) side down.

2. Close the transmitter case.

^

Make sure the seal is in position, then align the two halves of the case and snap them together.

3

Check the operation of the transmitter.
^

If the transmitter does not work it may need to be resynchronized. Refer to Resynchronization.

Normal battery life is approximately 2 years. The batteries should be replaced when the range of the transmitter begins to decrease significantly to
less than approximately 7 meters (23 feet).

Lock Cylinder Switch > < Remote Keyless Entry Module Replacement|Page 10131