Malibu V6-191 3.1L VIN M SFI (1997)
8. Hydraulic modulator assembly to bracket mounting nut.
9. Hydraulic modulator assembly.
INSTALL OR CONNECT
1. Hydraulic modulator assembly.
2. Hydraulic modulator assembly to bracket mounting nut. Tighten Nut to 30 Nm (22 ft. lbs.).
3. Brake pipes to Hydraulic Modulator. Use locations noted during removal.
WARNING: Make sure brake pipes are correctly connected to BPMV. If brake pipes are switched by mistake (inlet vs. outlet), wheel
lockup will occur and personal injury may result. Tighten Brake pipes to 24 Nm (18 ft. lbs.).
4. Motor Pack electrical connector.
5. Solenoid electrical connectors.
6. Upper radiator hose.
7. Battery tray.
8. Battery and bleed system. See: Hydraulic System/Service and Repair
9. Perform Diagnostic System Check. See: Testing and Inspection
Hydraulic Modulator Bracket
REMOVE OR DISCONNECT
1. Hydraulic modulator assembly.
