Malibu V6-191 3.1L VIN M SFI (1997)
toward the rear of the vehicle.
7.
Disconnect the electrical connector from the cruise release switch.
8.
Remove the cruise release switch (3) from the brake pedal bracket by grasping the switch and turning it 90 degrees counter clockwise while
pulling toward the rear of the vehicle.
9.
Disconnect the electrical harness from the brake pedal bracket.
10.
Remove the upper (1) and the lower (2) mounting nuts from the brake pedal assembly.
11.
Remove the brake pedal assembly.
12.
Install the brake pedal assembly into position.
13.
Install the upper and the lower mounting nuts to the brake pedal assembly.
Tighten
Tighten the mounting nuts to 27 Nm (20 lb ft).
14.
Connect the brake pedal pushrod to the brake pedal.
15.
Connect the electrical harness to the brake pedal bracket.
16.
Insert the stop lamp switch and cruise release switch into their containers until the switch body is seated on the retainer.
17.
Connect the electrical connectors to the stop lamp switch and cruise release switch.
Important:
Adjust the stop lamp switch and cruise release switch at the same time. The adjustment procedures for the switches are identical.
