Malibu V6-191 3.1L VIN M SFI (1997)
Fluid - A/T: Testing and Inspection
Fluid Level Set After Service
After service, set the fluid level according to the following procedure.
1. Add fluid through the fill cap hole prior to adjusting the fluid level. The amount of fluid to add should be based on the table at the end of this
procedure.
2. Follow steps 1-4 of the FLUID LEVEL DIAGNOSIS PROCEDURE.
3. Add additional fluid through the fill cap (1) hole in 0.5-liter (1-pint) increments until the fluid comes out through the screw hole.
4. Allow the fluid to finish draining out through the screw hole, then install the fluid level screw (2) and torque the screw to the proper specification
(12 Nm).
5. When the fluid level setting procedure is completed, wipe any fluid from the transmission case with a rag or shop towel. Also, check that the fluid
fill cap (1) and the vent tube are properly installed.
Bottom Pan Removal (On Vehicle) ............................................................................................................................................. 7 Liters (7.4 Quarts)
New Converter .......................................................................................................................................................................... 2.5 Liters (2.6 Quarts)
Complete Overhaul .................................................................................................................................................................. 10 Liters (10.6 Quarts)
