Malibu V6-191 3.1L VIN M SFI (1997)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
REMOVE OR DISCONNECT
1. Disconnect the negative battery cable.
2. Remove the serpentine drive belt.
3. Refer to Steering and Suspension for removal of power steering pump assembly.
4. Remove the electrical connector.
5. Remove the bolt.
6. Remove the sensor.
INSTALL OR CONNECT
1. Install the Camshaft Position Sensor.
Tighten
Retaining bolt to 10 Nm (8 lb. ft.).
2. Install the electrical Connector
3. Install the power steering pump.
4. Install the serpentine drive belt.