Malibu V6-191 3.1L VIN M SFI (1997)
Air Bag Control Module: Customer Interest
Restraints - Class Action Settlement - Reprogram SDM
Bulletin No.: 07-09-41-006
Date: August 08, 2007
INFORMATION
Subject:
SDM Reprogram - Class Action Settlement (U.S. Only)
Models:
1997-1999 Chevrolet Malibu
1997-1999 Oldsmobile Cutlass
PURPOSE
The purpose of this bulletin is to provide GM Dealers with information about Class Action Settlement CJ-2002-424 for certain 1997, 1998 and 1999
Chevrolet Malibu and certain 1997, 1998 and 1999 Oldsmobile Cutlass vehicles. As part of the settlement, GM has agreed to reprogram the air bag
sensing and diagnostic module (SDM) at no cost to the customer.
Reprogram the SDM in these vehicles if the customer presents a copy of the letter shown. Retain a copy of the customer letter with the CSO. Claims for
1997 and 1998 vehicles need to be H-routed through your ASM for payment approval before submitting a claim. Use the labor operation number and
time published in this bulletin to receive payment. The labor operation number in this bulletin is for bulletin use only. It will not be published in the
Labor Time Guide.
SERVICE PROCEDURE
The Tech 2 diagnostic tool must be updated with version 27.004 or later for reprogramming the air bag sensing and diagnostic module (SDM).
Turn the ignition switch to the "ON" position and verify that the "AIR BAG" warning lamp flashes seven (7) times and then turns "OFF".
If the AIR BAG warning lamp does not operate as described, perform the SIR diagnostic system check as described in the appropriate service manual
before proceeding.
Connect the Tech 2 to the vehicle's data link connector (DLC) under the instrument panel.
Turn the Tech 2 "ON" by pressing the power button.
Press "ENTER" to access the "MAIN MENU".
Use the "UP" and "DOWN" buttons (arrows) on the Tech 2 to move the highlight bar to the selections described in the following steps.
Select "DIAGNOSTICS" on the "MAIN MENU" screen and press "ENTER".
