Malibu V6-191 3.1L VIN M SFI (1997)
IMPORTANT: When replacing any transaxle mount, the remaining mount through bolts and mount bracket to cradle nuts need to be loosened, then
tightened in the following sequence:
1. Rear mount through bolt.
2. Rear mount bracket to cradle.
3. Front mount bracket to cradle.
4. Front mount through bolt.
5. Left mount through bolt.
NOTE: This procedure will eliminate engine/transaxle mount preload, which could cause driveability concerns. Tighten fasteners to manufacturers
specifications.
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Install J 28467-360 Engine Support Fixture.
3. Raise vehicle and support the vehicle.
4. Left front tire and wheel assembly, Refer to Steering And Suspension.
5. Left front splash shield.
6. Left transaxle mount bolts.
7. Left transaxle mount.
INSTALL OR CONNECT
1. Left transaxle mount.
2. Left transaxle mount bolts.
3. Left front splash shield.
4. Left front tire and wheel assembly, Refer to Steering And Suspension.
5. Lower vehicle.
6. Remove engine support fixture.
7. Negative battery cable.
