Malibu V6-191 3.1L VIN M SFI (1997)
3. Crimp seal retaining clamp (13) with J 35910 to 136 Nm (100 ft lb).
4. Spacer ring (9) on axle shaft (14) and beyond 2nd groove.
5. Slide spider assembly against spacer ring (9) on shaft (14).
Important: Be sure that counterbored face of spider (4) faces end of shaft (14).
6. Install shaft retaining ring (3) in groove of axle shaft (14) with J 8059.
7. Slide spider (4) towards end of shaft (14) and reseat spacer ring (9) in groove on shaft.
8. Place approximately half of grease from service kit in seal (12) and use remainder to repack housing (2).
9. Trilobal tripot bushing (11) to housing (2).
10. Position new larger clamp (10) on seal (12).
