Malibu V6-191 3.1L VIN M SFI (1997)
Fluid Pressure Sensor/Switch: Service and Repair
REMOVE OR DISCONNECT
1. Remove negative battery cable.
2. Remove transaxle case side cover.
3. Remove pressure switch assembly (6 bolts).
IMPORTANT: Inspect the O-rings for the pressure switch assembly for any damage.
INSTALL OR CONNECT
1. Install the pressure switch assembly making sure all O-rings are in place.
2. Torque the 6 bolts holding the pressure switch assembly to 12 Nm (9 ft. lbs.).
3. Install the transaxle case side cover.
4. Connect the negative battery cable.
5. Refill transaxle with fluid to proper level. Refer to 4T40E OIL LEVEL CHECKING AND FILL PROCEDURE.
