Malibu V6-3.1L VIN J (2002)
Hood Hinge: Service and Repair
Hood Hinge Replacement
Removal Procedure
1. Remove the air inlet grille.
2. Mark the position of the hood hinge on the fender and hood using a grease pencil.
3. Remove the hood.
4. Remove the lower hood hinge bolts from the fender.
5. Remove the hood hinge from the vehicle.
Installation Procedure
1. Position the hood hinge to the alignment marks on the fender.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the lower hood hinge bolts to the fender.
Tighten the bolts to 28 N.m (21 lb ft).
3. Install the hood.
4. Install the air inlet grille.
5. Align the hood. Refer to Hood Adjustment.
