Malibu V6-3.1L VIN J (2002)
1. Connect the vacuum hose harness connector (1) to the HVAC control assembly.
2. Connect the temperature actuator (2) to the HVAC control assembly.
3. Connect the blower motor switch electrical connector (3) from the HVAC control assembly.
4. Connect the rear defroster control electrical connector (4) from the HVAC control assembly.
5. Install the control assembly to the IP (2).
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the control assembly retaining screws (1).
Tighten
Tighten the control assembly screws to 2 N.m (18 lb in).
7. Install the accessory trim plate.
