Malibu V6-3.1L VIN J (2002)
6. Install the daytime running lights sensor wiring harness clip (1) from the HVAC module assembly.
7. Connect the IP lamp dimmer switch electrical connector (2).
8. Connect the vacuum supply hose (4) to the vacuum tank.
9. Install the air distribution duct.
10. Install the floor air duct to the HVAC module.
11. Install the cross vehicle beam (1) to the front of the dash (2).
NOTE: Refer to Fastener Notice in Service Precautions.
12. Install the nuts and bolts for the cross vehicle beam.
Tighten
Tighten the nut and bolts to 20 Nm (15 lb ft).
13. Install the steering column mounting brace bolts.
Tighten
Tighten the bolts to 26 Nm (19 lb ft).
