Malibu V6-3.1L VIN J (2002)
Dimmer Switch: Service and Repair
IP DIMMER SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the Instrument Panel (IP) cluster trim plate from the IP carrier.
3. Disconnect the hazard warning switch electrical connector if required.
4. Disconnect the electrical connector from the dimmer switch (2).
5. With a small flat-bladed tool release the retaining tabs (1) for the dimmer switch (2).
6. From the front of the IP cluster trim plate push outward on the dimmer switch (2).
This will remove the dimmer switch (2) from the IP cluster trim plate.
INSTALLATION PROCEDURE
1. Align the dimmer switch (2) with the opening in the IP cluster trim plate.
2. Push inward on the dimmer switch (2) until fully seated into the IP cluster trim plate.
3. Connect the electrical connector to the dimmer switch (2).
4. Connect the hazard warning switch electrical connector if required.
5. Install the IP trim plate to the IP Carrier.
6. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.
