Malibu V6-3.1L VIN J (2002)
11.
Disconnect the hazard warning switch electrical connector.
12.
Using a small flat-blade screwdriver, carefully release the two retaining features on the mounting bracket and remove the hazard warning switch
from the bracket.
13.
Install the mounting bracket on the new hazard warning switch.
14.
Connect the electrical connector to the new hazard warning switch and insert it through the center air outlet opening in the IP.
15.
Position the switch and mounting bracket to the IP and install the two attaching screws through the center air outlet opening.
Tighten
Tighten to 3 N.m (27 lb in).
16.
Through the instrument cluster opening in the IP, install the remaining hazard warning switch attaching screw.
Tighten
Tighten to 3 N.m (27 lb in).
17.
Install the cluster in the IP. Install the four screws.
Tighten
Tighten to 2 N.m (18 lb in).
18.
Connect the electrical connector to the trip reset switch.
19.
Install the IP cluster trim panel to the IP and install the two screws.
Tighten
Tighten to 2 N.m (18 lb in).
20.
Install the center air outlet in the IP.
21.
Install the bezel on the hazard warning switch.
22.
Verify hazard warning switch operation.
Grand Am
1.
Apply the parking brake.
2.
Using a small flat-blade screwdriver, carefully remove the ignition switch bezel.
